drying machine
Welcome to Sunco Machinery  |  Site Map  |  Contact us

NEWS CENTER

You are here: Home > News & Events >> Industry News

Hammer Mill Glass Crusher

Time:2014年07月16日      Hits:

One USA hammer mill glass crusher clients asked sunco machinery that: Two items as regards the hammer mill glass crusher: Cost...shipping, etc ?

Hammer Mill Glass Crusher, glass crusher, glass bottle crusher

How is glass crushed smaller than 5 mm accomplished ? The discharge size for the BC200x300 is stated as 0-30 mm.

Hammer Mill Glass Crusher

Sunco Machinery engineer answers are as follows:

In the crushing chamber of the glass crusher, there are hammers which are installed on the center shaft. The motor make the center shaft rotate in high speed. Thus, the hammers on the center shaft also rotates in high speed. 

The waste glass goes into the crushing chamber through the feed inlet, and it is crushed by the high speed hammers into small pieces.

On the bottom of the small glass crusher, there is half round sieve, and on the sieve there are many holes. Here we can make the hole size of the sieve to be 5 mm, then only the glass pieces less than 5mm can go through the 5mm sieve hole, the bigger than 5mm size glass pieces will be crushed again by the hammers until it is smaller than 5mm.

Please note that the sieve hole size of hammer mill glass crusher can be made according to your demand.

Inquiry
Note: Please feel free to give your inquiry in the form below. We will reply you with details within 24 hours.
Topic: *
Company:
Name: *
Tel: *
E-mail: *
Message: